HAKKINDA

  • ISSN: 2149-4916
  • E-ISSN: 2149-9373
  • Yayın Periyodu:
    Nisan - Ağustos - Aralık
  • Editör:İsmail ŞAHİN
  • Yıl: 2017
  • Cilt: 3
  • No: 2

DYNAMOMETER DESİGN AND MANUFACTURİNG FOR CUTTİNG FORCE DEFİNİTİON ON MACHİNİNG PROCESS

Hüseyin GÖKÇE,  Mehtap YAVUZ,  Mehmet KARAYEL, 

In this study; A load cell based dynamometer design and manufacture has been realized in which the shear forces that can be measured in a precise manner and the measured values can be simultaneously recorded in the computer environment. The developed dynamometer and shear force values obtained from the dynamometer commonly used in the literature are compared. Verification experiments were carried out by drilling 1040 material with 10 mm diameter HSS drills. In dry cutting conditions, the feed rate is 0.075, 0.1 mm/g. and the cutting speed is 15, 25 m/min. When the results of the verification experiments are compared, it is seen that the data obtained from the manufactured dynamometer and the results obtained from the commonly used dynamometer show similar results. It has been demonstrated that with this production system, these measurements can be made at a cost corresponding to about 5% of the dynamometer cost existing in the sector

Anahtar Kelime: Drilling,  cutting force,  dynamometer,  load cell

Tam Metin (PDF) Kaynakça


Makale Gönder